Opening The Configuration Manager - Auerswald COMpact 4000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
Note: If the permanent IP address from the APIPA address range is not working, you will
first have to learn the IP address allocated by the DHCP server. You have the following
options:
• If the UPnP service is installed and activated on the PC (e. g. on Windows 8), the PBX
can be found and selected in the network environment as "COMpact 4000" device.
• You can use a network scanner (f. e. Angry IP Scanner).
• You can connect a CLIP-capable analogue telephone and query the IP address by
entering the character string ##8*941# and then hanging up the receiver.
Important: If you wish to operate the PBX in a network where IP addresses are allocated
permanently, you must first connect a CLIP-capable analogue telephone and adapt the IP
configuration of the PBX for operation in the network (see next chapter).
Configuring a Permanent IP Address in the PBX
1.
Pick up the receiver of an internal telephone.
2.
In sequence, dial ##8, the 6-digit admin PIN (none in the factory settings) and *930*0#.
You will hear the confirmation tone (pulsating tone).
The DHCP client function is disabled in the PBX.
3.
Hang up the receiver and then pick it up again.
4.
In sequence, dial ##8, the 6-digit admin PIN (none in the factory settings), *931*, the
12-digit IP address (e. g. for 192.168.2.10: 192168002010) and #.
You will hear the confirmation tone (pulsating tone).
The entered IP address has been configured in the PBX (for subnet mask
255.255.255.0).
5.
Hang up the receiver.

Opening the Configuration Manager

Requirements:
• PC with a min. screen resolution of 1024 x 768
• Recommended Browser: Mozilla Firefox (current version), Google Chrome (current
version)
1.
Enter the IP address of the PBX in the address field of the browser. Example for entering
the permanent IP address: https://169.254.1.240.
Since the PBX forces an HTTPS connection, your browser will provide a safety warning
(because of the missing safety certificate).
2.
If necessary, transmit the safety certificate to your working environment (user and
browser profile).
3.
Click with wizard (recommended).
4.
Use the configuration wizard to carry out the system activation and configure the basic
settings.
COMpact 4000 - Instructions V05 10/2018
First Setup
41

Publicidad

Tabla de contenido
loading

Tabla de contenido