Publicidad
Idiomas disponibles
Idiomas disponibles
7. ACTIVATION AND USE OF THE ICE MAKER
The filter kit should be installed in an accessible
location (such as an adjacent cabinet) to allow for
the water filter cartridge to be changed annually.
If you choose not to use the water filter (such as
connecting the appliance to an already filtered
water source) then it is suggested to also set the
function Water Filter throught the icon
the icon reset and disable the warning to avoid
receiving reminders to change the filter (that you
are not using).
7.3 Filter Cartridge Replacement
AP2 FILTER CARTRIDGE REPLACEMENT
! WARNING !
To reduce the risk associated with choking:
> Do not allow children under 3 years of age to
have access to small parts during the
installation of this product.
To reduce the risk associated with the ingestion
of contaminants:
> Do not use with water that is
microbiologically unsafe or of unknown quality
without adequate disinfection before or after the
system. Systems certified for cyst reduction
maybe used on disinfected water that may
contain filter able cysts. EPA Establishment
#070595-Mex-001
CAUTION:
To reduce the risk associated with property
damage due to water leakage:
> Read and follow replacement instructions
before replacement of the filter cartridge.
> Protect from freezing, remove filter
cartridge when temperatures are expected to
drop below 33° F (1° C).
28
HOW TO REPLACE THE FILTER CARTRIDGE (Fig.1 )
IMPORTANT: The disposable filter cartridge
MUST be replaced every 6 months, at the rated
capacity or sooner if a noticeable reduction in
flow rate occurs.
Note: The system is equipped with an internal by-
pass valve.
A. Turn cartridge slowly to the left, about 1 /4
,touch
Ice Maker
Water Filter
turn, until it stops. At this position both inlet and
outlet ports are closed and water pressure has
Water System Purge
been relieved. B. Pull used cartridge straight down
and discard. Note: There maybe a small amount of
residual water drainage after pressure is relieved
and during cartridge removal. C. Make sure the o-
rings are positioned correctly in grooves. Moisten
the o-rings with water. Push new cartridge into
filter head. Turn cartridge 1/4 turn to the right
until it stops. Top surface of cartridge will
become flush with bottom of the head when fully
engaged. D. Open faucet or down stream valve (if
installed) and flush new filter cartridge for two
minutes, expelling any trapped air and carbon fines.
Water may run cloudy with air but will quickly
clear.
Publicidad
