Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY (Note: When fastening with nuts
and bolts, always use a washer (#25, #26, or #27)
between the tube and the bolt or the tube and
the nut.)
Step 1:
Fasten the front and rear upright supports (#2
and #3) at the top by using bolts (#17), washers
(#25), and steel nuts (#28). Repeat the same
procedure for both sides. Keep the bolts loose.
See Fig. A – Step 1.
Step 2:
At both ends, insert the assembled upright
supports (#2 and #3) into the top cross beam
w/adjustable teeth (#1). Tighten all of the nuts
and bolts now. See Fig. A – Step 2.
Step 3:
Fasten the lateral cross braces (#4) to the
upright supports (#2 and #3) by using bolts
(#18), washers (#26), and plastic nuts (#29).
Repeat the same procedure for both sides.
See Fig. A – Step 3.
Step 4:
Fasten the rear cross brace (#5) to the rear
upright supports (#3) by using bolts (#18),
washers (#26), and plastic nuts (#29). Tighten
all of the nuts and bolts. See Fig. A – Step 4.
Step 5:
Insert the leg caps (#16) into all of the base feet.
See Fig. A – Step 5.
V-3
17
17
Step 1
Fig. A
DO NOT RETURN TO THE STORE!
STOP
PAGE 3 OF 8
25
25
28
25
25
28
3
2
Do not tighten the bolts
after step 1, fasten all of
the bolts after step 5.
Step 3
3
2
2
4
Step 4
3
5
Step 5
3
2
16
16
1
Step 2
3
2
2
18
3
26
26
4
3
26
26
18
3
2
16
16
3
29
29
Publicidad
