Toro Flex-Force Power System 51855T Manual Del Operador página 9

Specifications
Model 51855T
Cutting 610 mm (24 inches)
Length
Rated
60V DC maximum, 54 VDC nominal usage
Voltage
Cutting 19 mm (3/4 inch)
width
Charger Toro 60V lithium-ion chargers
Type
Battery Type Toro 60V lithum-ion batteries
Appropriate Temperature Ranges
Charge/store the battery pack
at
Use the battery pack at
Use the machine at
*Charging time will increase if you do not charge the
battery pack within this range.
Store the machine, battery pack, and battery charger
in an enclosed clean, dry area.
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous.
5°C (41°F) to 40°C (104°F)*
-30°C (-22°F) to 49°C (120°F)*
0°C (32°F) to 49°C (120°F)*
Operation
Starting the Hedge Trimmer
1. Remove the protective cover from the blades
(Figure 4).
WARNING
The hedge trimmer blades can cause
cuts or amputation.
Be careful when handling the hedge
trimmer with the protective cover
removed.
1. Protective cover
2. Make sure that the vents on the hedge trimmer
are clear of any dust and debris.
3. Align the cavity of the battery pack with the
tongue in the handle housing, grasp the handle,
and push the battery pack into the handle until
the latch locks into place
1. Auxiliary-handle switch
2. Auxiliary handle
3. Lock switch
4. Place 1 hand on the trigger handle. Place the
other hand on the auxiliary handle
7
Figure 4
2. Blades
(Figure 5).
Figure 5
4. Trigger
5. Battery latch
6. Hedge trimmer venting
areas
(Figure
g308414
g308413
5).