Measuring Procedure - Kerbl 29392 Instrucciones De Uso

Measuring procedure

1. For a correct measurement please ensure that the device has the same temperature than the material you want to
measure (+/-3°C). For that reason, let your device adjust to the surrounding temperature of the material for at least
half an hour before measuring (protect from direct sunlight!).
2. Switch on the device: Press the
3. To change the calibration curve, please press the
4. Plug the probe into the material. The display shows the water content immediately.
5. Pay attention to the direction of plugging in! (pay attention to the following page!)!
6. To save the results in the save menu press the
cessful when the number in front of the symbol
please press ( ) until the
ATTENTION! Risk of injury!
Direction of plug in
Insert the device into the bale like shown in the picture below. Any other direction of plugging lead to a significant devia-
tion of the measuring results. Pull the unit straight out again. Any mechanical damage due to mishandling is no case of
guarantee.
key for 3 seconds.
or
( button). The storage was suc-
increased. To reach the store menu
appears.
Round bales have to be measured on the face side. Measure-
ments at the bearing surface lead to miss readings.
15
key.
Rectangle bales have to be measured on the
face side. Measurements at the other side can
lead to miss readings.