Technical Data - Kerbl 29392 Instrucciones De Uso

Technical data

Resolution of the display
Measuring range
Operation temperature
Temperature measuring range
Storage temperature
Temperature compensation
Power supply
Auto Switch Off
Current consumption
Display
Dimensions
Weight
Degree of protection
Scope of supply
!IMPORTANT! Please read!
Most common reasons for miss readings
• Product temperature out of application range
Material below 0°C resp. above +40°C may cause faulty measurements. The storage of cold material in a warm storage area usually creates
condensed water which may lead to major measuring errors.
• Discrepancy in temperature between device and material
Please ensure that the device and the material under test are being stored at the same temperature (+/- 3°C) before measuring. Protect your
measuring device from direct sunlight for a reasonable time period before taking a measurement. A high temperature difference has a negative
effect on the stability of the measurement results.
• Wrong calibration curve
Double check the correct selection of the calibration curve before measuring.
• Wet or mouldy material
• Frozen measuring material or material containing snow
This leads to a major decrease in accuracy.
• Direction of plugging in
The Direction of plugging has a great influence on the accuracy. Necessarily follow the instructions according to the beginning of the manual!
• Compressed density outside the application range
If the compressed density differs from that specified, there may be deviations!
• Moving the measuring head after the plug in leads to miss readings!
• Water film at the measuring head
After measuring wet material a water film can arise on the sensor head. This could lead to a too high result in the following measurements.
After measuring wet material clean both black plastic parts of the measuring head accurately with a dry cloth.
ATTENTION: Risk of injury by measuring head! Keep away from children younger than 16 years!
0,1% water content
0,5°C temperature
8 to 30 % (60%)
0°C to 40°C
-15°C to 85°C (only measuring head)
-20°C to 60°C
automatically
4 pcs. 1,5 Volt AA Alkaline
batteries (for approx. 1000 measurements)
after approx. 6 minutes
55 mA (with light)
128 x 64 matrix display, lighted
740 x 65 x 40 mm
approx. 450g (incl. batteries)
IP 40
device FLK,
Rubber protection
4x1,5Volt AA Alkaline batteries
19