Publicidad
Idiomas disponibles
Idiomas disponibles
3
• The pulsator rotates for 8
seconds to detect the
laundry load.
• Then the WATER LEVEL
and the amount of
Detergent to be used will
be shown and water will
be supplied.
4
4
4
4
Close the lid
5
• Water will be
• When the wash
supplied for 2
program ends, the
minutes after the
buzzer will ring for
start of the wash
10 seconds
to supplement
before the Power
the water the
goes off
laundry has
automatically.
absorbed.
6
6
6
6
Finish
• If water is already in the tub, or putting wet
6
laundry into the tub before starting will
increase the WATER LEVEL.
• With lightweight bulky loads, WATER LEVEL
can be set low.
• Changes to Water Temperature
(HOT/COLD) and wash level are possible
during operation.
(refer to page 14)
• When setting the WATER LEVEL manually, do
not set to Medium to prevent damage to
7
laundry.
• Washing with HOT water may damage the
laundry (Water is set to cold automatically).
Ensure that the load is under 2kg.
• In order to avoid damage to laundry, the spin
cycle may appear slow.
This also avoids wrinkles and clothing may still
contain some water. This is normal.
• When static pressure of water is more than
7
2kg/cm
2
, the QUICK WASH course will be
within 19min.
7
7
Caution & Note
17
Publicidad
