LAVOR Pro GV8,6 Manual De Instrucciones página 24

Electric controls
The machine is equipped with an electric control panel-board situated in the
machine front side.
The various devices present on the panel-board are described below:
Reference Descripion
1 - MAIN SWITCH: It is a 2-position selector that energises the
machine if turned to ON.
Vice versa, the machine is de-energised if turned to OFF.
2 - LINE white pilot light: it turns on when the machine electric
system is energised.
3 - THERMOREGULATOR: refer to paragraph "Temperature
adjustment".
4 - TANK WATER LEVEL red pilot-light: it turns on to signal a
lack of water in the tank.
5 - BOILER START luminous green push-button: it starts the
boiler.
6 - GUN START luminous orange push-button: it starts the gun.
7 - 24V FUSE.
8 - 220V FUSE.
Detergent
supply
push-button
Steam supply
lever
Machine start
Steam gun
Use of the steam gun
- Put the gun plug in the special socket then block it by
means of the two levers;
- Press the GUN STAR orange luminous push-button situated
on the control panel;
- Supply the steam by means of the gun lever;
- Supply the detergent product by pressing the red push
button situated on the gun left side together with the steam
supply lever: no effect will be produced by pressing just the
push-button.
WARNINGS
- For any eventual regulation, setting or parts replacement
not foreseen in this manual, please contact the Manufacturer
or Seller's personnel.
- Before carrying out any replacement make sure that:
• the main switch is "OFF".