Descargar Imprimir esta página

Schumacher Electric SE-40MAP Manual Del Usuario página 7

Ocultar thumbs Ver también para SE-40MAP:

Publicidad

Idiomas disponibles

Idiomas disponibles

2.3
This charger employs parts, such as switches and circuit breakers, that tend to
produce arcs and sparks. If used in a garage, locate this charger 18 inches or
more above floor level.
2.4
NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.
2.5
Be extra cautious to reduce the risk of dropping a metal tool onto the battery.
It might spark or short-circuit the battery or other electrical part that may cause
an explosion.
2.6
Use this charger for charging LEAD-ACID batteries only. It is not intended to
supply power to a low voltage electrical system other than in a starter-motor
application. Do not use this battery charger for charging dry-cell batteries that
are commonly used with home appliances. These batteries may burst and
cause injury to persons and damage to property.
2.7
NEVER charge a frozen battery.
2.8
NEVER overcharge a battery.
3.
PREPARING TO CHARGE
3.1
Consider having someone close enough by to come to your aid when you work
near a lead-acid battery.
3.2
Have plenty of fresh water and soap nearby in case battery acid contacts your
skin, clothing or eyes.
3.3
Wear complete eye and body protection, including safety goggles and
protective clothing. Avoid touching your eyes while working near the battery.
3.4
If battery acid contacts your skin or clothing, immediately wash the area with
soap and water. If acid enters your eye, immediately flood the eye with cold
running water for at least 10 minutes and get medical attention right away.
3.5
If it is necessary to remove the battery from the vehicle to charge it, always
remove the grounded terminal first. Make sure all of the accessories in the
vehicle are off to prevent arcing.
3.6
Be sure the area around the battery is well ventilated while the battery is being
charged.
3.7
Clean the battery terminals before charging the battery. During cleaning, keep
airborne corrosion from coming into contact with your eyes, nose and mouth.
Use baking soda and water to neutralize the battery acid and help eliminate
airborne corrosion. Do not touch your eyes, nose or mouth.
3.8
Add distilled water to each cell until the battery acid reaches the level specified
by the battery manufacturer. Do not overfill. For a battery without removable
cell caps, such as valve regulated lead acid batteries (VRLA), carefully follow
the manufacturer's recharging instructions.
3.9
Read, understand and follow all instructions for the charger, battery, vehicle
and any equipment used near the battery and charger. Study all of the battery
manufacturer's specific precautions while charging and recommended rates of
charge.
3.10
Determine the voltage of the battery by referring to the vehicle owner's manual
and make sure that the output voltage selector switch is set to the correct
voltage. If the charger has an adjustable charge rate, charge the battery in the
lowest rate first.
Risk of contact with battery acid. Battery acid is a
highly corrosive sulfuric acid.
3

Publicidad

loading