Tramontina SC27 Manual De Uso página 14

!
To avoid serious personal injury and damage to the unit, shut the unit off before removing or installing blower
tubes.
Installing the blower tubes
Installing the Upper Blower Tube:
1. Set the unit on a flat, level surface.
2. Rotate the upper blower tube (2) so that the "TOP" lock tab is facing up (Fig. 01, Pag. 04).
3. Align the "TOP" lock tab on the upper blower tube (2) with the groove on the blower outlet (3), (Fig. 02, Pag. 04).
4. Push the upper blower tube (2) onto the blower outlet (3), (Fig. 03, Pag. 04).
5. While holding the handle firmly, turn the upper blower tube clockwise until it locks into place (Fig. 03, Pag. 04).The tab on
the upper blower tube (2) should align with the tab on the blower outlet (3), (Fig. 03, Pag. 04).
Installing the Lower Blower Tube:
1. Align the tab on the lower blower tube (1) with the groove on the upper blower tube (2), (Fig. 04, Pag. 04).
2. Push the lower blower tube (1) onto the upper blower tube (2), (Fig. 04, Pag. 04).
3. While holding the handle firmly, turn the lower blower tube (1) clockwise until it locks into place (Fig. 04, Pag. 04). The tab
on the lower blower tube (1) should align with the tab on the upper blower tube (2), (Fig. 04, Pag. 04).
removing the blower tubes
Removing the Lower Blower Tube:
1. Set the unit on a flat, level surface.
2. While holding the handle firmly, turn the lower blower tube counterclockwise until it unlocks from the upper blower tube
(Fig. 04, Pag. 04).
3. Remove the lower blower tube (1) from the upper blower tube (2), (Fig. 04, Pag. 04).
Removing the Upper Blower Tube:
1. While holding the upper blower tube firmly, carefully insert a flat-head screwdriver under the TOP lock tab (Fig. 05, Pag.
04).
2. Gently twist the screwdriver to lift the lock tab away from the blower outlet. Repeat this step with a second lock tab (Fig.
05, Pag. 04).
3. Remove the upper blower tube (2) from the blower outlet (3), (Fig. 05, Pag. 04).
For proper engine operation and maximum reliability, pay strict attention to the gasoline and oil mixing instructions
!
on the 2-cycle oil bottle. Using improperly mixed fuel can severely damage the engine.
Gasoline is extremely flammable. Ignited vapors may explode. Always stop the engine and allow it to cool before
!
filling the fuel tank. Do not smoke while filling the tank. Keep sparks and open flames at a distance from the area.
Remove the fuel cap slowly to avoid injury from fuel spray. Never operate the unit without the fuel cap securely
!
in place.
Add fuel in a clean, well ventilated outdoor area. Wipe up any spilled fuel immediately. Avoid creating a source of
!
ignition for spilled fuel. Do not start the engine until fuel vapors dissipate.
Fueling
Use good quality gasoline mixed with 4% (25:1) 2-stroke oil in the fuel tank (Fig. 06, Pag. 05). The tank has a
capacity of 473 ml.
14
ASSEMBLY OF EQUIPMENT
FUELING