Publicidad
Idiomas disponibles
Idiomas disponibles
Start Up
Bit Fitting
1. Put the bit into the chuck until it stops.
2. Fasten with the chuck wrench and tighten alternately
the chuck into each of the orifices.
Turn on and operation control
• Intermittent operation:
Connect the plug into the power inlet.
Press the switch (A) to start the hammer drill.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power inlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
Speed control
The tool can run in different speeds. Select by adjusting speed control in the
switch.Turn speed control clockwise to increase the hammer drill speed and torsion.
Turn counterclockwise to lessen speed and torsion.
Changing from hammer drill to drill
• To drill concrete, floor tile or materials of similar hardness, move the impact-rotation selector
completely into the IMPACT (
simultaneously impact and rotate onto the material.
• To drill metal, wood or plastic, move the impact-rotation selector completely into the
ROTATION (
) position (pointing towards the chuck). The bit will rotate onto the material.
Do not try to drill metal; wood or plastic with the hammer drill into IMPACT
WARNING
(
) mode setting. Otherwise the tool efficiency will lessen and the bit tip would get
damaged.
Rotation direction
• To get the bit to rotate forward and drill, move the rotation selector lever towards
the arrow pointing the chuck.
• To get the bit go reverse and use the tool as a screwdriver, move the rotation
selector lever towards the arrow pointing the hammer drill handle.
WARNING
Never use the tool in reverse when the impact-rotation selector is
in the IMPACT (
) position, otherwise, the impact system will be severely
damaged.
Note: The marking is on the rotation selector lever. The image is only for reference.
Adjusting depth control rod
• Loosen the auxiliary handle knob to move the depth control rod
into the desired position. To fix the rod into the new position tighten
the knob.
) position (pointing towards the chuck). The bit will
Bit
1
2
Speed
control
Switch
Chuck
Chuck
wrench
Continuous
operation button (B)
Switch (A)
Impact-Rotation
selector
Rotation selector lever
in the drilling position
Rotation
selector lever
7
ENGLISH
Publicidad
