Publicidad
Idiomas disponibles
Idiomas disponibles
Number
600
1000
1400
1800
2200
2600
3000
3500
Caution: The constant speed and power
controller can be turned only as far as 3500 and
back to 600. Do not force it past 600 or 3500, or
the speed adjusting function may no longer work.
Polishing Operation
●
Please adjust the speed to a lower speed when
used the machine as a polisher.
*Caution: Always wear goggles and mask
during operation.
1. When using the tool for polishing, do not
force the tool on the surface of the workpiece
to be polished. Sometimes the weight of
the tool applies adequate pressure. Forcing
and excessive pressure will result in poor
performance and dangerous. At the same time, it
will also lead to tool overload and motor burning.
2. Sanding disc, polishing oil or wax oil should be
selected in accordance with the material and
desired surface finish. Maximum polishing effect
will be attained by following method:
Preliminary polishing with sander using a fine-
grain sanding disc.
Polishing with a polishing guard using polishing
oil or wax. Apply a small quantity of oil or wax on
the material surface before polishing.
Caution: When using the tool for polishing,
do not force the tool on the surface of the
workpiece to be polished. Sometimes the
weight of the tool applies adequate pressure.
Forcing and excessive pressure will result in
poor performance and dangerous. At the same
time, it will also lead to tool overload and motor
burning. Apply polishing oil or wax oil on the
workpiece in accordance with the material and
desired surface finish before polishing.
EN
10
Speed(/min)
600
1000
1400
1800
2200
2600
3000
3500
Maintenance and Care
Caution: Always be sure that the tool is
switched off and unplugged before attempting
to perform inspection or maintenance.
Clean the air vents
●
The air inlet and air outlet of the tool should be
cleaned regularly or at any time when it is blocked.
1
Check the mounting screws
●
Should always check whether mounting screw
fastening safely. If found loose screws, shall be
immediately to tighten, so as to avoid an accident.
After Use
●
Do not put down the tool immediately after the tool
is turned off. Wait until the tool completely stops
before putting it down. This can not only avoid
accidents, but also reduce a large amount of dust
and fine debris being sucked into the tool.
Check the Carbon Brushes
●
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip
in the holders. Both carbon brushes should be
replaced at the same time.
1
Replace the Carbon Brushes
●
Use a screwdriver to remove the brush cover, take
out the worn carbon bush and replace a new one,
and then tighten the brush cover securely.
1.Air Outlet
2.Air Inlet
2
1.Limit Mark
Publicidad
