Publicidad
Idiomas disponibles
Idiomas disponibles
means Polisher)
Rated Power Input
Rated Speed
Wheel Size
Net Weight
Intended Use
The machine is intended for polishing and brushing
metal and coated surfaces as well as for polishing
stone without the use of water.
Instructions for Operation
9
8
1.Bow handle
2.Fastening screw for bow handle
3.Thumbwheel for speed preselection
4.Handle
5.On/off switch
6.Auxiliary handle
7.Polising sponge
8.Grinder spindle
9.Spindle lock button
● Installing or Removing Polishing Sponge
To install the polishing sponge, fix the spindle by
pushing the spindle lock, and then tighten the
polishing sponge on the spindle.
To remove the polishing sponge, simply fix the
spindle by pushing the spindle lock, and then
unscrew the polishing sponge.
Caution: Always be sure that the tool is
switched off and unplugged before installing or
removing the polishing sponge.
12A
600-3500/min
180 mm
3.4 kg
1
2
3
4
5
6
7
1
2
Switch Operation
●
To start the tool, simply pull the switch button.
Release the button to stop. For continuous
operation, pull the button and then push in the lock
button. To stop the tool from the locked position,
pull the button fully and then release it.
Caution: Before plugging in the tool, always
check to see that the switch trigger actuates
properly and returns to the "OFF" position
when released.
1
2
Speed Adjusting
●
The tool speed can be changed by turning
the constant speed and power controller
(thumbwheel for speed preselection) between
600/min to 3500/min to meet different needs.
The number (600-3500) on the controller means
different speed. Higher speed is obtained
when the controller is turned in the direction
of number 3500. And lower speed is obtained
when it is turned in the direction of number
600.
1
Refer to the table for the relationship between
the number settings on the controller and the
approximate tool speed. (Note: The data in the
table is for reference only due to the influence of
relevant uncertain factors).
1.Spindle
2.Polishing
Sponge
1.Lock Button
2.Switch Button
1.Constant
Speed and Power
Controller
EN
9
Publicidad
