EINHELL 41.389.51 Manual De Instrucciones Original página 15

4. Technical data
Max. loosening torque .............................340 Nm
Max. torque .............................................340 Nm
Working range (max. thread size) ................ M14
Max. permissible working pressure ......... 6.3 bar
Idling speed ........................................7500 min
Square drive mount ................12.7 mm (1/2 inch)
Air consumption .................................. 142 l/min.
Recommended hose diameter ................... 9 mm
Weight ........................................................1,9 kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN ISO 15744.
L sound pressure level ........................ 99 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ........................ 110 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) were determined in accordance with EN
ISO 15744 and EN ISO 28927-2.
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
Anl_TC_PW_340_for_Kit_SPK9.indb 15 Anl_TC_PW_340_for_Kit_SPK9.indb 15
-1
= 4.8 m/s
2
h
2
- 15 -
GB
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the power
supply make sure that the data on the rating plate
are identical to those of the supply voltage.
Disconnect the compressed air supply before
performing any cleaning, adjusting and main-
tenance work.
Air supply:
Via a compressed air source with pressure setting
function, e.g. a compressor. Before starting up,
please also read the section on care and mainte-
nance.
Performance values of the compressor:
The compressor used should have a tank volume
of at least 50 liters.
Setting values for work with the suction
spray gun:
Set a maximum working pressure of 6.3 bar at
your compressed air supply.
Remember:
Wear the necessary protective clothing, in
particular safety goggles, when working with
the screwdriver.
Pay attention to the safety regulations.
06.08.2020 08:39:28 06.08.2020 08:39:28