DoorBird D11 Serie Manual De Instalación página 9

Important note for cavity mounting (e.g. in pedestals and mailboxes):
To protect the electronic units, please ensure that the technical components are protected
against dripping and running water caused by condensate or entering the mounting space
through openings.
To protect the electronic units, ensure that the mounting space inside is not accumulating water.
Sufficient air circulation must be ensured, as well as unobstructed drainage of water at the base
of the installation.
Failure to do so will result in warranty being declined.
4
ASSEMBLING THE MOUNTING HOUSING
The product is available as a surface-mounted and flush-mounted version. In the flush-mounted version, the front
panel is slightly larger to better cover the hole in the wall, and the mounting housing (backbox) is made entirely
of metal instead of plastic. If you use the flush-mounted housing, lever up the wall accordingly.
If the wall of the house is not made of wood, you should drill dowel holes 5 mm (0.19 in) in diameter in the wall
according to the drilling template and then place the dowels provided into the boreholes.
If you must drill holes in a wall, insert screws into a wall or lever up a wall, ensure that no cables or mains
(gas, water, etc.) are to be found in the wall.
If the wall of the house is made of wood, dowels are not normally required. There are special dowels for
assembling the device on an insulating wall, e.g. Fischer insulating dowels.
4.1 DISASSEMBLING THE FRONT PANEL
Remove the front panel with the attached Main Electrical Unit carefully from the mounting housing (backbox)
using the orange (Torx+Pin) screw driver provided.
We have designed the front panel and safety screws in a way that they cannot be screwed through the
front panel so that they do not fall off / get lost during installation.
D1101V
Turn the safety screws counter-clockwise until
they are loose.
D1102V D1101KH
Turn the safety screws counter-clockwise until
they are loose.
9