① Pressing this key in the modes except of the fan mode, the sleep function switches between
(12) Sleep
② When pressing this key, the wind speed is automatically switched to low wind. However, the
opening and closing. Switching mode will cancle sleep function.
wind speed can be adjusted according to the wind speed key (except of the dehumidification
mode).
① When the first power on, there is lamplight by default. Pressing this key force to turn off or turn
(13) Light
on the lamplight. Decide whether to have this function according to the actual model.
① This key is used to set the clock. Pressing enters the hour adjustment state, and the hour
(14) Clock
digital tube on the LCD is flickering at the same time. The hour can be set by temperature
② When the hour is set, press this key again to enter the minute adjustment state, and the
addition or reduction keys, and it ranges from 0 to 23.
minute digital tube on the LCD is flickering at the same time. The minute can be set by
③ After adjusting, press the clock key again to confirm the setting and the adjustment state exits.
temperature addition or reduction keys, and it ranges from 00 to 59.
If do not press the clock key again to confirm, the time adjustment state will exit after 3
seconds, and recover the clock before the adjustment.
① There is no lock by default. Pressing this key, the lock function switches between opening and
(15) Lock
② When it is locked, the remote controller does not work except the lock key.
closing.
① Extension code remote controller has the effect. Switch 3 gear wind and 6 gear wind. There is
(16) Combinatorial key: "FAN -" + "FAN +"
6 gear wind on the LCD. If the 3 gear wind is switched, the first and second gear wind will be
"low wind"; the third and fourth gear wind will be "middle wind"; the fifth and sixth gear wind
will be "high wind".
① Enter address setting
(17) Combinatorial key: "Mode" + "Lock"
1)
On the shutdown interface, press the combinatorial key on the remote controller for 5
seconds to enter the address setting interface.
2)
The last address (when the first power on, 00 is displayed) and the "#" icon are displayed
② The step instructions of setting address
and flickering.
1)
At the address setting interface, press the temperature addition or reduction to adjust the
setting address, and it ranges from 00 to 63.
V.2