Publicidad
Line spool installation
• Set the pressure turn table onto the cutter head (7).
• Set the flange onto the turn table (8).
• Insert the Allen key into the turn table side to block the
axis (5).
• Place the threaded spool in the axis
and tighten counterclockwise using
your hand (9).
• Use the guard with the protection.
See the guard section.
Balancing the brushcutter
• Wear the harness and adjust to set it firmly and
comfortably.
• Join the harness into the harness ring of the straight axis
of the brushcutter.
• Travel the ring upwards and downwards until the
brushcutter is balanced and the cutter head points down,
below the user's waist and no more than 30" away from
the ground.
• When using the line spool, the cutter head shall touch
the ground slightly (A).
• When using the blade, the cutter head shall be
approximately 8" away from the ground (B).
8
ENGLISH
9
8
7
5
A
Assembly
B
8"
Publicidad
