Publicidad
2
GLIDER ASSEMBLY - BACK SEAT SETUP
2a. Align the Metal Channel on the Back
Rest (2) to the Metal Prongs on the
Seat (1).
2b. Slide the metal channel into the metal
prongs on the seat frame.
2c. Please ensure that the back metal
channel goes into the base metal
prongs until it clicks and locks itself.
2d. After clicking the back into position,
raise the glider's base and attach the
Washers (B) and Bolts (A) to the
insertions on the glider base
connecting the back rest to the seat.
2e. Pull the back rest upward to ensure
that it is fully secured, and then use the
recliner.
WARNING:
Make sure the glider's back is
•
securely attached to the seat.
Improper installation may result in
•
injuries due to fall hazards from a
loose back.
A
Bolt (x2)
Boulon (x2)
Perno (x2)
14
B
Washer (x2)
Rondelle (x2)
Arandela (x2)
(B)
(A)
www.evolurbaby.com/help
2
1
(B)
(A)
Publicidad
