Publicidad
Idiomas disponibles
Idiomas disponibles
Before Use
Removal and Installation
Please remove the protective strips from both sides of the robot vacuum.
Take out the side brush, and install it onto the position as indicated in the figure.
The side brush is properly installed when you hear a "click".
Side Brush
Protective Strip
Charging
Remove the protective film from the charging dock. Place the charging dock against
a wall and connect it to the power. Then place the robot vacuum onto the charging
dock to charge.
CAUTIONS:
Do not place the charging dock in an area with direct sunlight.
Please ensure that no items are placed within 0.5 m on the le and right sides and
within 1.5 m in front of the charging dock.
It is recommended to fully charge the robot vacuum before using it for the first
time to maintain its optimal ba ery performance and maximize ba ery life.
The robot vacuum will turn on automatically when it is on the charging dock, and
cannot be turned off while charging.
Connecting with Mi
Home/Xiaomi Home App
This product works with the Mi Home/Xiaomi Home app*. Use the Mi
Home/Xiaomi Home app to control your device, and to interact with other
smart home devices.
Scan the QR code to download and install the
Protective Strip
app. You will be directed to the connection
setup page if the app is installed already. Or
search "Mi Home/Xiaomi Home" in the app
store to download and install it.
Open Mi Home/Xiaomi Home app, tap "+" on the upper right, and then
follow prompts to add your device.
* The app is referred to as Xiaomi Home app in Europe (except for Russia). The name of
the app displayed on your device should be taken as the default.
Notes:
• The version of the app might have been updated, please follow the instructions based
on the current app version.
• If the robot vacuum's QR code cannot be scanned, you can search for its name to add it.
• When connecting the robot vacuum to the Mi Home/Xiaomi Home app using an iOS
device, follow the instructions in the app to connect to the robot vacuum's hotspot
"ijai-vacuum-v17_miapXXXX".
Rese ing Wi-Fi
While the robot vacuum is turned on, press and hold the bu ons
seconds. The Wi-Fi is successfully reset when you hear a voice prompt.
Rese ing System
Press and hold the bu on
press and hold the bu on
The robot vacuum then restarts, and se ings like scheduled cleaning and Wi-Fi are
restored to factory default.
06
and
for five seconds until you hear a "beep", and then
for five seconds again until you hear the voice prompt.
8A347322
for seven
Publicidad
