Tangent DAC II Manual Del Usuario página 6

Indicator Function
Power/Standby indicator
Power: Power on-The product in power off status, then push the power source button on rear panel at
"ON" position the LED indicator blinks one time and the startup sound from electric relay in the unit, after
about 2 seconds the amplifier will be in working status. Note that the unit will remember the settings
from before it was powered off.
Power off:
Push the power source button at "OFF" position, and unit will go into power off status.
Standby:
Press the OFF button on the remote control, or push the Volume/selector button, then the unit will go into
standby, and the standby LED will be red color. The unit is in standby status.
(When the DAC II goes into auto standby when inactive in 15min, you can wake it up via audio signal again)
Power on : Press the desired input on the remote control or push (long press) the Volume/
(from standby mode)
selector button. And after about 2 seconds the amplifier will be in last time working status before standby.
Bluetooth input indicator
Press BT to select Bluetooth as your audio source.
Optical input indicator
Press Optical 1 or 2 to select input method as optical audio source.
COAX input indicator
Press COAX to select COAX input.
USB input indicator
Press USB to select USB input.
Volume and input switch button
This selector can adjust volume (turn left or right) and also switch the input mode (push)
(For standby push and hold the button)
(UK)