Horizon Global 65086 Instrucciones De Instalación página 4

NOTE: Requires trimming of lower air dam for hitch installation. Obtain owner permission before trimming.
1. Remove and trim lower air dam – Using a 7mm socket remove several fasteners from the lower air dam and remove from vehicle. Locate center line of air dam or have
customer mark center of air dam before removal. Using a tape measure, marker, and utility knife or grinder, cut out the center 3.5" of the air dam up to the reinforcing web.
Make (2) 1.5"notches as shown in Figure 1 in the reinforcing webs. Then, reinstall the lower air dam using a 7mm socket. See Figure 1.
M7 fasteners
2.Remove factory nuts and passenger side bolts – Using an 18mm socket and 18mm end wrench, remove the (2) factory M12 flange bolts holding the passenger side tow hook.
Using an 13mm socket, remove (2) bolt from under body panel. Remove (1) clip nut from each frame rail. Remove the flange nut from the driver side tow hook and slide the bolt
flush with the frame. The passenger side tow hook will rest inside the frame. Be careful not to let it fall forward. The driver side tow hook will stay bolted in place with the rear bolt.
(outside of passenger frame rail view)
©2023 Horizon Global™ Corp - Printed in Mexico
Passenger Tow Hook Bolts
Figure 1.
Driver Tow Hook Flange Nut
(outside of driver frame rail view)
Sheet 4 of 15 65086NP 1-5-23 Rev. A