Publicidad
Idiomas disponibles
Idiomas disponibles
3. Loosely install hitch – Using pull wire, feed the carriage bolts and spacers into frame rails using access hole shown in Figure 2. Hand tighten the supplied M12 bolts
and washers (item 1 and item 2) and the front driver side tow hook flange bolt. Hand tighten the M12 hex nuts (item 2) and front driver side tow hook flange nut.
Install the (2) passenger side tow hook flange bolts and flange nut. Make sure the passenger side flange bolts also engage the tow hook. Remove pull wires and loosely
install conical washers, flat washers and hex nuts to hitch, see Figure 2.
©2023 Horizon Global™ Corp - Printed in Mexico
Driver side tow hook flange
nut on flange bolt
4. Tighten all M12 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M) and 7/16-14
fasteners to 50 Lb-ft. (68 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 5 of 15
Passenger Side tow hook
flange bolts
65086NP
1-5-23
Rev. A
Publicidad
