Descargar Imprimir esta página

One for All URC1281 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
SETUP
LEARNING
Your Essence remote control can learn any function from any other
working remote control. This is a quick and easy one-time setup that
allows to control any infrared controlled device you have in your living
room. It also allows you to add a key or keys that may be missing to a
spare key on the Essence.
To do this, firstly make sure you have all your original remote controls
to hand, and that they have working batteries in.
To learn functions, the original remote should be approximately 3cm
from the Essence remote, pointing towards it:
1.
2.
3.
4.
5.
6.
7.
8.
* Some remotes send commands differently. If you find a function
cannot be learned, try holding down the key on the original remote
instead of pressing and releasing.
Hints:
• If the LED shows one long blink at step 5, the function was not
learned correctly, please try again from step 4.
• If you find one or more keys don't work properly after set up,
you can re-enter the learning mode at any time by repeating the
procedure from step 1.
• If one or more of your original remotes aren't working, you can still
set up the Essence remote by SimpleSet or Code Set Up.
713430_1-3_21T_Printfile_URC1281_ESSENCE_8_RDN1150323.indd 6
713430_1-3_21T_Printfile_URC1281_ESSENCE_8_RDN1150323.indd 6
Press the Device key for the device you want to
learn functions onto.
Hold down the Setup key until the LED under the
Device key blinks twice.
Press 975 – the LED should blink twice.
Press and release the key you want to learn a
function onto (for example the TV Power key) –
the LED will begin to flash rapidly.
Press and release* the corresponding key on the
original remote, for example Power.
The LED will blink twice to indicate the key has been learned
correctly.
Repeat steps 4 and 5 for each key you want to learn –
remember you can learn from multiple remotes, but only one
function per key.
When you have learned all the functions you
require, press and hold Setup key until the LED
blinks twice.
2 - 5 CM
6
22-03-2023 11:51
22-03-2023 11:51

Publicidad

loading