Silverline 802165 Manual De Instrucciones página 9

Performing a bevel cut
• To adjust the bevel angle of the Table Surface (4):
1. Undo Bevel Angle Lock Front (8) and Rear (7)
2. Tilt the table to the desired angle, and Lock the Bevel Angle Lock Front and Rear to secure the
position, (Image H)
Note: The bevel angle is displayed on a graduation scale beneath the Bevel Angle Lock Front.
• Ensure the Straight Fence (9) is secure, and use it as a guide when cutting the workpiece
• Take extra care of the Cutting Disk (5) when performing bevel cuts
Accessories
• A range of accessories and consumables, including Tile Cutting Diamond Disc is available from
your Silverline stockist. Spare parts can be obtained from toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection,
maintenance or cleaning.
Replacing the cutting disk
WARNING: ALWAYS wear suitable cut proof gloves when handling the Cutting Disk (5). Not doing so
may result in cuts, or harm to the operator.
1. Remove the Water Sump (1), ensure the blade housing area is dry and turn the machine on its
side so the blade housing is facing upwards
2. Unscrew and remove the four Philipps head screws holding the blade cover on (Image I)
3. Remove the blade cover to reveal the Cutting Disk (5) and spindle assembly (Image J)
4. Place the Spanner (13) over the locking nut, and use the Spindle Spanner (14) to secure the
spindle. Undo the locking nut using the Spanner (Image K)
5. Remove the outer flange from the spindle to reveal the disk. Pull the disk off the inner flange
6. Replace the Cutting Disk, being sure that it is the correct orientation and that it is correctly seated
on the inner flange (Image L)
Note: The spindle will spin in an anticlockwise direction when viewed with the blade cover removed.
Ensure the correct disk is installed in the correct orientation.
7. Reinstall the outer flange and tighten the lock nut onto the spindle
8. Replace the blade cover and return the tile cutter to its normal working position
9. Switch the machine on, allow the Cutting Disk to get up to speed, and check that it is running
smoothly and 'true'
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be
carried out by an authorised Silverline service centre. This advice also applies to extension cords
used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol
or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an authorised Silverline
service centre
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
Tile Cutter 450W
9