Worx Nitro WG855E Manual Original página 15

Bag capacity
Heigt adjustment
levels
Level Height Level
+6 mm -3 mm -6 mm -9 mm
Machine Weight
(Bare Tool)
**X=1-999, A-Z, M1-M9 there are only used for
different customers, there are no safe relevant
changes between these models.
***Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
SUGGESTED BATTERIES
AND CHARGERS
Category
20V Battery WA3014
20V Charger WA3883
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store person-
nel can assist you and offer advice.
NOISE DATA
A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection
VIBRATION INFORMATION
Typical weighted vibration
Uncertainty
WARNING: The vibration emission value during
actual use of the power tool can differ from the
2×20V cordless lawn
scarifier/aerator 2 in 1
40 L
4(Level +1,Level 0,Level
-1,Level -2)
Level Level Level
+1 0 -1
10.45 kg
Type Capacity
4.0 Ah
4.0 A
L =74.3 dB(A)
pA
3.0 dB(A)
L =88.0 dB(A)
wA
3.0 dB(A)
a <2.5 m/s²
h
K=1.5 m/s²
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
Using the correct accessory for the tool and ensuring it
-2
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4.INTENDED USE
This product is intended for domestic lawn scarifying/
aerating.
5.OPERATION INSTRUCTION
NOTE: Read instruction handbook before
operation this machine.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the handles
Choosing the appropriate
height of the handles and
assembling the handles.
NOTE: The height of both
sides should be the same.
Attaching the cable clips
FIGURE
See Fig. A1, A2,
A3, A4, A5, A6, A7
See Fig. B
EN
15