12
3.3. REASONABLY FORESEEABLE MISUSE
Never use Hose reel without first mounting it on a wall or ceiling.
Do not make any unauthorised changes or modifications.
en
Do not use in potentially explosive atmospheres.
Do not use with flammable gas.
Not for use where there is exposure to intense heat, direct sunlight, naked flames or liquids.
Do not pull Hose suddenly.
Do not use Hose close to sharp edges.
Lay Hose flat along the floor, do not kink and avoid looping.
3.4. DUTIES OF THE OPERATING COMPANY
The operating company must ensure that personnel who work on the product comply with the
regulations and provisions together with the following instructions:
National and regional regulations for safety, accident prevention and environmental protection
regulations.
No damaged products are assembled, installed or commissioned.
The necessary protective equipment is provided.
3.5. PERSONAL PROTECTIVE EQUIPMENT
Comply with the national and regional regulations for safety and accident prevention. Protective
work wear appropriate for the risks associated with the intended activities must be selected,
provided and worn.
Wear foot protection, protective gloves, hearing protection and safety glasses.
3.6. QUALIFICATIONS OF PERSONNEL
Specialists for mechanical work
Specialists in the sense of this documentation are persons who are familiar with assembly work,
mechanical installation, commissioning, troubleshooting and maintenance of the products and
who possess the following qualifications:
Qualification / training in the field of mechanics as specified in the nationally applicable regula-
tions.
Trained person
Trained persons in the sense of this documentation are persons who have been trained to perform
work in the areas of transport, storage and operation.
4. Device overview
A
1
Bracket
2
Casing
5. Installation
5.1. WALL OR CEILING MOUNTING
B
ü Choose wall plugs and screws matching the wall or ceiling.
1. Position bracket on smooth surface and mark two drilling positions.
▶ Do not mount on wall or ceiling more than 3 m above the floor.
2. Drill holes, screw bracket firmly onto mounting surface with suitable screws and wall plugs.
3
Stop
4
Pneumatic tool connection
Instruction manual
5
Compressed air supply connection