Silk’n SILKYAIR PRO HCA01 Manual De Usuario página 13

7 Storage
EN
All parts must be completely dry before being stored. Store the
product in a clean and dry place, avoiding heat and direct sunlight.
8 Troubleshooting
Some problems may be caused by minor faults that you can fix
yourself. To do so, follow the instructions in the following table.
If it is still not possible to resolve the problem, contact customer
service. Do not repair the product yourself.
Fault
The product
does not
operate.
The hair is
singed.
Error message
E01 or E04–
E10 shows in
the display.
Error message
E02 or E03
shows in the
display.
9 Technical data
Model:
Voltage:
Power:
Motor speed:
Max. air speed:
Noise level:
Weight:
13
Possible cause and solution
• Make sure the product or mains cord is not
defective, and the mains cord is properly
connected to a mains socket.
• The product overheats. Unplug the product
and wait until it has completely cooled down
before using again.
• The selected operating temperature is too
high. Select a lower temperature.
• There is an internal error. Contact
customer service for support.
• The voltage is either too low or high.
Connect the product to an appropriate
mains socket.
HCA01
220–240 V, 50/60 Hz
1,600 W
110,000 rpm
76 km/hr
≤ 75.7 dB (30 cm)
approx. 676 g (EU), 715 g (GB)