SONNIGER CR ONE Operación Y Mantenimiento página 12

Operation and maintenance documentation HEATER CONDENS EC v202301
1. Fan Speed: LOW, MED, HI and AUTO
2. ROOM TEMP. or NTC EXTERNAL SENSOR TEMP. (measured
temperature)
3. Anti-freeze indication
4. Automatic programable mode
5. Manual mode
6. 6 Time Zones for each day
7. Cooling Mode
8. Heating Mode
9. Ventilation Mode
10. Buttons Lock
11. SET TEMP. (desired room temperature)
12. ON/OFF status of time zones
Technical parameters
1 Power supply
2 Temperature setting range
3 Temperature working range
4 IP class
5 Temperature sensor
Dimensions
Settings menu
When Panel Intelligent is switched off, press and hold MODE for 5 seconds
To change the option use the MODE button.
To change the value using the +/- buttons
Setting menu
1
2
3
4
5
6
7
8
9
10
11
Button lock / unlock
To LOCK buttons press and hold + and then – and hold both of them for 5 seconds.
To UNLOCK buttons press and hold + and then – and hold both of them for 5 seconds.
230VAC/50Hz
5°C 40°C
-10°C 60°C
20
Internal / external NTC (optional)
Option
Temperature calibration
EEPROM
Fan status
Temperature sensor
Antifreeze
Antifreeze range
ALARM
Drycontact
MODBUS
BMS speed
Modbus ID
13 MODE Press shortly to select manual or automatic
mode Press and hold for 3 s and select colling,
heating or ventilation mode
14 FAN Press shortly and select fan speed: Low, Med,
High or Auto
15 ON/OFF INTELLIGENT Panel
Value
–9°C ~ +9°C
0:nomemory
1: memory
C1: Thermostatic mode
C2: Continuous mode
0: Internal Sensor
1: External Sensor NTC (optional)
0: Off
1: On
+5°C ~ +15°C
0: disable
1: enable
0: NO
1: NC
0: disable
1: enable
0-2400 / 1-9600 / 2-19200
1~247 (01~F7)