SONNIGER CR ONE Operación Y Mantenimiento página 4

Operation and maintenance documentation HEATER CONDENS EC v202301
3.
GENERAL INFORMATION
HEATER CONDENS heating and ventilation devices are manufactured in compliance with standards concerning quality, ecology,
utility and work comfort. HEATER CONDENS devices are delivered ready-to-use in a cardboard package that is to protect from
mechanical damage. The package consists of: the device, the Manual (Operation and Maintenance Documentation) and the
Guarantee. If the optional automatic control in ordered, it shall be delivered in a separate package. Make sure all the aforemen-
tioned elements are in the package immediately after delivery. In the absence of any element, please fill in the suitable carrier
document.
 Before mounting read the manual carefully and adhere to the rules concerning the mounting procedures. Not apply-
ing may result in inappropriate functioning of the device and the loss of the guarantee rights.
 Pay special attention when working with electrical elements of the device.
 Any installation operations must be carried out by qualified persons with appropriate authorizations
4.
ASSEMBLY
Before any installation procedures, consider the following aspects: easy access for maintenance works, access to water and
electrical installation, and appropriate air distribution in a room.
Each HEATER unit is equipped with a set of 2 interchangeable color inserts; to change the color, remove the insert from the
front panel and place the desired one back in place.
It is advisable to mount the device to the wall or the ceiling on original mounting brackets, supporting mount pins (not delivered
with the device), or supporting constructions (shapes and dimensions of the supporting construction may be individually de-
signed in compliance with durability and strength requirements).
In case of mounting to the ceiling, pay attention to the fact that air-release/venting of the device may be difficult so it is advis-
able to place the vent at the highest point of the pipework.
The device may be mounted to the wall with the use of a mounting bracket at the angle of 0°, 30°, or 60 °. A mounting brack-
et holder is made of a curved profile. It has two holes for vertical assembly. Assembly to the wall and/or to the ceiling is possi-
ble at different angles but it requires making necessary holes in the holder.
ATTENTION !