Publicidad
Idiomas disponibles
Idiomas disponibles
Back off the setscrews in the sleeve, and with a twisting
motion install the sleeve on the spout supply tube until it
contacts the washer surface.
Align the sleeve so the setscrews are not facing directly
forward or backward.
Tighten the setscrews.
When supplied, position the ring over the sleeve so it rests
upon the washer.
Apply a ring of plumbers putty or other sealant around the
underside of the decorative ring (if supplied) according to
the putty manufacturer's instructions. Otherwise, apply
the putty to the underside of the spout.
CAUTION: Risk of product damage. Use care
when installing the spout assembly to prevent
damage to the O-ring seal on the sleeve.
When supplied, fit the decorative ring over the washer.
Install the spout assembly onto the sleeve, and carefully
press down until the spout base contacts the deck, rim, or
tile.
Align the spout as desired, and tighten the setscrew.
If included, press the plug button into the setscrew hole.
Kohler Co., Kohler, WI U.S.A.
Sleeve
Spout
Apply Plumbers
Putty To Decorative
Ring Or Spout
Plug
Button
Setscrew
9
Setscrew
Setscrew
Fig. #18
Î
Fig. #19
Î
Decorative Ring
(When Supplied)
Fig. #20
1013201-2-
A
Publicidad
