Publicidad
2.8 ASRock Smart Remote Installation Guide
ASRock Smart Remote is only used for ASRock motherboard with CIR header.
Please refer to below procedures for the quick installation and usage of ASRock
Smart Remote.
Step1.
Find the CIR header located next
to the USB 2.0 header on ASRock
motherboard.
Step2.
Connect the front USB cable to the
USB 2.0 header (as below, pin 1-5)
and the CIR header. Please make
sure the wire assignments and the
pin assignments are matched
correctly.
Step3.
Install
Multi-Angle CIR Receiver
the front USB port. If
CIR Receiver
receive the infrared signals from
MCE Remote Controller, please try
to install it to the other front USB
port.
1.
Only one of the front USB port can support CIR function. When the
CIR function is enabled, the other port will remain USB function.
2.
Multi-Angle CIR Receiver
use the rear USB bracket to connect it on the rear panel.
CIR Receiver
down and front), which is compatible with most of the chassis on the
market.
3.
The Multi-Angle CIR Receiver
Please install it before you boot the
* ASRock Smart Remote is only supported by some of ASRock motherboards. Please refer to
ASRock website for the motherboard support list: http://www.asrock.com
26
USB_PWR
1
ATX+5VSB
to
Multi-Angle
cannot successfully
3 CIR sensors in different angles
is used for front USB only. Please do not
can receive the multi-direction infrared signals (top,
does not support Hot-Plug function.
system.
ASRock A55 Pro3 Motherboard
USB 2.0 header
(9-pin, blue)
CIR header
(4-pin, white)
P-
P+
GND
DUMMY
2
3
4
5
GND
IRTX
IRRX
Multi-Angle
Publicidad
