Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
Cleaning Your Appliance
Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.
•
Turn off the appliance first and then unplug the unit from the wall outlet.
•
Remove all contents.
•
Wash the inside with a damp warm cloth soaked in lukewarm water and baking soda solution.
•
The solution should be about 2 tablespoons of baking soda to a quart of water.
Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.
•
The outside of the appliance should be cleaned with mild detergent and warm water.
•
Dry the interior and exterior with a soft cloth.
•
Changing the Inner Light
Before removing the inner light, turn off the appliance first and then unplug the unit from the wall outlet.
•
Failure to do so could result in electrical shock or personal injury.
•
Using a screwdriver, remove the two screws from the clear plastic cover.
•
Tilt the panel towards the front of the appliance and unscrew the LED board from the black plastic spacer.
•
Gently unclip the power cable from the red socket insert on the LED board.
•
Insert the power cable into the red socket insert on the replacement LED board.
•
Position within the black plastic spacer.
•
Reassemble the LED board, spacer and cover together using the two screws.
•
Reposition the panel and carefully enclose the cord within the LED housing.
•
Reattach the clear plastic panel using two screws.
Important: The replacement of LED lamp can only be performed by an authorized technician.
Vacation Time
•
Turn off the appliance first and then unplug the unit from the wall outlet.
•
Remove all the contents.
Clean the appliance.
•
Leave the lid open slightly to avoid possible formation of condensation, mold, or odors.
•
Use extreme caution in the case of children. The unit should not be accessible to child's play.
•
Short vacations: Leave the appliance operating during vacations of less than three weeks.
•
Long vacations: If the appliance will not be used for several months, remove all contents and unplug
•
the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave the door
open slightly: blocking it open if necessary or have the door removed.
Moving Your Appliance
•
Turn off the appliance first and then unplug the unit from the wall outlet.
Remove all the contents.
•
Securely tape down all loose items inside your appliance.
•
Tape the doors shut.
•
•
Be sure the appliance stays in the upright position during transportation.
Energy Saving Tips
The appliance should be located in the coolest area of the room, away from heat producing
•
appliances or heating ducts, and out of the direct sunlight.
Let hot contents cool to room temperature before placing in the appliance. Overloading the appliance
•
forces the compressor to run longer.
Be sure to wrap contents properly, and wipe containers dry before placing them in the appliance. This
•
cuts down on frost build-up inside the appliance.
Organize and label contents to reduce door openings and extended searches. Remove as many items
•
as needed at one time, and close the door as soon as possible.
6
Publicidad
