Uline H-9180 Instrucciones De Ensamble página 3

6. Place desktop (1) upside down on a smooth,
non-marring surface to prevent scratching.
Grommets should be facing down.
7. Place adjustable frame on top of desktop (1).
Adjust position of adjustable frame so that it is
centered on the desktop. (See Figure 5)
NOTE: Adjustable frame is designed to fit
desktops that are 48-72" long and 24-30"
wide. Extend adjustable frame as needed to
position desktop.
For 60 x 30" desks, top support brackets
should be approximately 1½" from side edges
of desktop and approximately 5½" from front
and back edges of desktop.
For 72 x 30" desks, top support brackets
should be approximately 6" from side edges
of desktop and approximately 5½" from front
and back edges of desktop.
Figure 5
PAGE 3 OF 18
ASSEMBLY CONTINUED
8. Attach top support brackets and adjustable frame
9. Place programmable handset (6) in desired location
1
to desktop using drill and eight 5 x 20 mm wood
screws (11). (See Figure 6)
NOTE: Desktop does not include pre-drilled
holes. Drill wood screws directly into desktop
to attach base.
Figure 6
11
11
on front edge of desktop. Attach using a drill and
two 5 x 20 mm wood screws (11). (See Figure 7)
NOTE: Back of desktop has two grommet holes.
Front of desktop is the opposite side.
Figure 7
6
11
11
11
1022 IH-9179