Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
The appliance is intended only for domestic use, not for professional use. The following
description is associated with the image on page 2:
1.
Permanent filter
2.
Filter holder
3.
Pause-and-serve function
4.
Glass pot lid
5.
Glass pot
6.
Measuring spoon
7.
Water reservoir
Unpack the device and remove all packaging parts. Clean the device before using for the first
time (see 'Cleaning and maintenance').
Place the appliance on a flat and steady surface.
1.
This appliance must be connected to an earthed socket.
2.
Open the lid of the water reservoir (7). Pour sufficient water into the reservoir (not less
3.
than 2 cups and not more than 12 cups, as shown on the water-level indicator (8).
Use the permanent filter (1) or put a paper filter (1 x 4) in the filter holder. Fill the paper
4.
filter with the required amount of ground coffee (the customary quantity is 1 level scoop
(6) for each cup).
Connect the plug (10) to the wall socket. Switch on the appliance by pushing the On/Off-
5.
button on the control panel (11). The control light will now illuminate and the coffee will be
prepared.
6.
It is also possible to delay the brewing of coffee. Set the time in the display to the current
time using the 'Hour' and 'Min' buttons. Then click on 'Prog' and use 'Hour' and 'Min' to
set the time when the coffee machine should start. Click 'Prog' again, the start time is
now set.The pause-and-serve (3) function enables you to pour a cup of coffee before
the coffee maker has finished. Replace the glass pot quickly, to prevent the filter from
overflowing.
The coffee machine automatically stops when the brewing is done. If you wish to halt the
7.
brewing prematurely, you can push On/Off again. The control light will extinguish.
Remove the plug from the wall socket.
8.
Allow the appliance to cool down before using it to brew additional coffee!
CLEANING AND MAINTENANCE
Open the filter holder. Dispose of the paper filter or remove the permanent filter from the
1.
casing, clean it in warm water and dry it thoroughly.
2.
Remove the opened filter holder from the housing and clean it with warm water and dish
soap. Then rinse well with clean water and dry thoroughly. Place the filter holder back in
the housing and put the permanent filter back.
Clean the glass pot in hot washing-up water.
3.
Clean the outside of the appliance with a damp cloth. Make sure no moisture gets into the
4.
appliance.
Only the glass pot, permanent filter and filter holder may be immersed in water and are
dishwasher safe. Never use corrosive or scouring cleaning agents or sharp objects (such as
knives or hard brushes) to clean the appliance.
Descaling
We advise the use of a suitable descaling agent to remove any scale. Always follow the
instructions for the descaling agent. The amount of scale will be reduced when you use a
water softener.
SERVICE
If an unexpected problem occurs, please visit www.bestron.com/service for assistance.
8.
Water-level indicator
9.
C offee maker housing
10.
Power chord and plug
11.
Control panel with control light:
- Hour
- Min
- Prog
- On/Off
12
EN
Publicidad
