Brew Monk 057.700.30 Instrucciones De Uso página 32

EN - Instruction Manual Brew Monk
2.5.1 Manual Mode Setting
1. Switch on the power switch, then press the MANUAL button.
2. TEMP is for Temperature setting, POWER is for Wattage setting, TIMER is for step timing.
These 3 must be set before machine will start; they can be set in any order. Use "-" and
"+" to set the desired level.
3. Press START button when all 3 settings have been entered, and the manual session will
start. There is an "H" flashing in the top left corner, this means the machine is heating.
4. • The default boiling temperature is 100°C, the timer will not be triggered if temperature
does not indicate 100°C. In this case, please put the cover on for 1-2 min. to achieve
100°C on the display.
• If the machine starts to boil, but shows a lower temp on the display, make the
following adjustment to set the temp at 100°C and trigger the timer.
• Press "-" and "+" button together until the display shows the C1/F1 sign. Temperature
correction range is from -10°C to +10°C or -50°F to +50°F
5. When you press the MANUAL/PAUSE button during heating, display will go back to edit
page. You can edit TEMP, POWER, TIMER, then press MANUAL/PAUSE button again to
confirm and the machine follows new settings.
6. Press TEMP 5 seconds long and release it to switch from degree centigrade to
Fahrenheit. This operation can only be executed in the BLANK PAGE.
2.5.1.1 Memory Function in Manual Mode for 1
1. Press MANUAL/PAUSE button in edit page for 5 seconds and release it. You can
record the last setting. There's an audio signal (ringing bell) when it has recorded
successfully.
2. Press START button after above operation, the machine will execute the entered
data.
3. Press STOP button, the machine stops working and goes to BLANK PAGE.
4. To restore factory settings press the AUTO/PAUSE button in BLANK PAGE for
5 seconds long, an audio signal (slower ringing) indicates you have successfully
restored factory settings.
Press MANUAL again,
32
TEMP
Press START button, machine starts working, there's an "H" flashing
Press MANUAL/PAUSE button during heating. Machine goes to edit page.
You can edit TEMP, POWER AND TIMER, press MANUAL button to confirm.
Press MANUAL/PAUSE button 5 seconds long in edit page, then release it.
The audio signal (ringing bell) indicates you recorded the data successfully.
machine restarts.
mashing step
st
MANUAL/PAUSE
POWER
in the top left corner.
TIMER
Press STOP,
machine stops.