Brew Monk 057.700.30 Instrucciones De Uso página 33

2.5.2 Auto Mode Setting
1. Switch on the device, then press AUTO button.
2. S1 will be shown on the top left corner, input the 3 settings - TEMP, TIMER and POWER
(as in manual mode using "+" and "-").
3. After you have set the 1
setting. 3 to 9 steps are set as 1
rd th
to confirm and go to the next step.
4. Once TEMP is set to 100°C, it automatically changes from MASHING to BOILING.
5. Setting hop reminder in boiling process: After setting the TEMP, TIMER and POWER for
boiling, press AUTO. Set time for hop 1 using "+" and "-". Press TIMER button for 2
3 , ... hop reminder. For example: 60 minutes boiling and after 10 minutes first hop
rd
addition, the hop reminder TIMER should be 50 minutes.
6. When you have entered the required steps (up to 9), press the START button to confirm
the above step settings. The brewing process will start. The current step will blink in the
upper left corner.
7. If 9 steps are too much for your recipe, set all temperatures below boiling by pressing
TEMP button after your last step. The programme only supports one boiling setting in
each recipe. You can adjust the boiling power during operation anytime.
2.5.2.1 During MASHING and BOILING
1. When 1 step is finished, there is an audio signal (reminder ringing), programme
st
will not proceed with the 2
is the ingredients filling reminder.
2. The boiling reminder is same as above, when machine finishes the step before
boiling, there is an audio signal (reminder ringing). The programme will not
proceed with the boiling step unless you press the AUTO button for
confirmation. It is the sparging reminder.
3. PAUSE button will stop the Brew Monk and timer working temporarily, and you can
modify the data, afterwards press AUTO to continue.
4. If you press the START button when auto mode is running, this will skip the
current step.
5. If you press the STOP button to skip all the steps, the machine stops working,
display shows END, bell rings for 30 seconds. Press the STOP button again enter
to BLANK PAGE.
2.5.2.2 Memory Function in Auto Mode
1. After setting all the data you need in auto mode, press STOP button until BLANK
PAGE. Please do not switch off the machine! Follow the steps below for recording.
2. Press MANUAL button to enter manual edit page, then press MANUAL button
5 seconds long, then release it. You can record the last manual and auto mode
setting. There is an audio signal (ringing bell) for successful recording.
3. Switch off/on the machine, then press AUTO button, the 1
programme will be shown on the display.
4. Press START button, machine starts working.
5. Our programme does not support batch storage. For each entry, you need to
repeat the instructions above.
step, press AUTO button again, then enter into 2
st
and 2 . For each step (3-9) press the AUTO button
st nd
step unless you press the AUTO button to confirm. It
nd
Instruction Manual Brew Monk - EN
step of last chosen
st
step
nd
,
nd
33