Publicidad
Idiomas disponibles
Idiomas disponibles
Operation:
1. Connect the power lead to the power socket with earth line. The machine will start heating.
2. You have to wait some time (about 10 minutes) until the machine has sufficiently warmed up.
Press the "A" or "B" key on the remote controller. The machine will spray fog and the LEDs will light in
different colours. Press it as long as you need. For safety reasons, the pump will only work when the
machine is hot enough.
3. Can set the machine at a high place (with bracket) or on the ground. Do not spray fog to people directly
and the lean angle should less than 15
4. Often check whether there is enough fog liquid in the tank. The unit might be seriously damaged if it
operates without fog liquid.
5. If the fog is small, plum has noise or there has no fog, please power off and check fog liquid, fuse, the
connector of remote console and power plug. If the problem could not be solved after check these parts,
please stop check and send it back to distributor for repair.
DMX Operation
Connect the unit on a DMX controller or insert it into a DMX chain via a DMX cable and set the start address
via the DIP switches.
The unit has 5 DMX channels that are allocated as follows :
Channel
Description
CH1
Fog output
CH2
Auto colour change mode red-blue-green
Red ON
CH3
CH4
Green ON
CH5
Blue ON
Value of the DIP switches
DIP
Value
DMX addresses for several units connected in series
Position
1
1+5
1+6
of
the
DIP
switches
1
2
3
Position
of
the
unit
in
the DMX
chain
Attention:
Please obey all notices about operation, safety and repair to avoid getting an electric shock and keep the
excellent effect.
Keep clean
0
.
1
2
3
1
2
4
1+5+6
1+7
1+5+7
1+6+7
4
5
6
7
4
5
6
7
8
16
32
64
1+5+6+7
1+8
8
9
© C o p y r i g h t L o t r o n i c 2 0 1 4
8
9
128
256
1+5+8
1+6+8
1+5+6+8
10
11
12
3
Page
Publicidad
