Descargar Imprimir esta página

SUHNER MACHINING MAX 40 R Documentación Técnica página 26

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
1. n
1.1 g
eneral notes on safety
This operation manual is applicable for the machine MAX
40 R.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the machIne for purposes for
whIch It Is Intended
The machine is designed for axial and/or radial machining
like milling, drilling, reverse drilling, boring, grinding, chip
breakage, countersinking, and reverse countersinking.
This machine is specifically ideal for plant construction.
1.3 I
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclaratIon of IncorporatIon
The manufacturer SOMEX S.A.S., F-68190 Ensisheim,
hereby declares for the partly completed machinery (see
reverse side for type and serial no.) that the following fun-
damental requirements of the Directive 2006/42/EC are
applied and fulfilled in accordance with Annex I: 1.1.2,
1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1, 1.5.1, 1.5.4, and 1.6.1.
Technical documentation was generated for the partly
completed machinery in accordance with Annex VII of the
Machinery Directive. Document Agent: I. Sebben. Author-
ised sites are provided with this technical documentation
in paper or electronic form on justified request. This partly
completed machinery may be put into operation only
when the machine in which the partly completed machin-
ery is to be incorporated has been ascertained to fulfil the
conditions under the Machinery Directive. F-Ensisheim,
10/2020.
I. Sebben/Division manager
2. c
2.1 a
ssembly InstructIons
Maximum admissible machine fastening
error.
The machine is fastened at the bores pro-
vided in the housing.
Screws of quality grad 8.8 must be used. The starting tor-
que for the holding down bolt is maximum 55Nm.
26
s
otEs on
aFEty
oMMissioning
Connect the cables only after the machine has
been completely installed.
2.1.1 f
astenIng of the machIne on Its mount
Correct lifting of machine with a crane.
2.2 c
onnectIng the power to the machIne
2.2.1 m
otor
The bridges must be set on the terminal board before the
motor is connected.
After the motor has been connected, the spindle's
sense of rotation must be checked. Correcting a
wrong sense of rotation involves swapping over
any two of the phase conductors.

Publicidad

loading