Publicidad
Idiomas disponibles
Idiomas disponibles
SWS96285RD
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service
manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all
cautions and warnings included in the shop manual. Read and follow all instructions carefully. This product is only designed to function properly on
specific vehicle applications. Please verify that the vehicle requirements match the product specifications and application notes for this part.
STEP 32: Install stabilizer links into U-brackets and
threaded bullets using supplied hardware packaged
with links and tighten to 40 ft-lbs. Install such that the
grease fittings face the front of the vehicle.
STEP 33: Recheck angle, making equal adjustments to both stabilizer links and maintaining a minimum of
5/8" thread engagement in both sides of the links. Tighten jam nuts to 20 ft-lbs.
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto
technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in
property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National
Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
Dorman Products, Inc. | Corporate Office and Customer Service: 1-800-523-2492
©2022 No reproduction in whole or in part without prior written approval.
INSTALLATION INSTRUCTIONS:
STEERING WOBBLE KIT
Upper and lower grease
fittings should face towards
the front of vehicle away
from the coil spring. M10 bolt
head should be positioned on
outboard side of bracket and
thread into mating threads on
inboard side of bracket.
Disclaimer:
17
SWS96285RD_Instructions
Publicidad
