Renishaw NC4 Guia De Instalacion página 6

Ocultar thumbs Ver también para NC4:

Patentes

Las características del sistema de reglaje de herramientas sin contacto NC4 y de otros productos

Renishaw similares están sujetas a una o varias de las siguientes patentes o solicitudes de patentes:

CN 100394139

EP 1502699

Microchip software licensing agreement

This product's firmware has been developed by Renishaw with the use of the Microchip libraries, under the

following licensing terms:

This software is developed by Microchip Technology Inc. and its subsidiaries («Microchip»).

Redistribution and use in source and binary forms, with or without modification, are permitted provided

that the following conditions are met:

1 .

Redistributions of source code must retain the above copyright notice, this list of conditions and the

following disclaimer .

2 .

Redistributions in binary form must reproduce the above copyright notice, this list of conditions and

the following disclaimer in the documentation and/or other materials provided with the distribution .

3 .

Microchip's name may not be used to endorse or promote products derived from this software without

specific prior written permission.

THIS SOFTWARE IS PROVIDED BY MICROCHIP «AS IS» AND ANY EXPRESS OR IMPLIED

WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF

MERCHANTABILITY AND FITNESS FOR PURPOSE ARE DISCLAIMED . IN NO EVENT SHALL

MICROCHIP BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR

CONSEQUENTIAL DAMAGES (INCLUDING BUT NOT LIMITED TO PROCUREMENT OF SUBSTITUTE

GOODS OR SERVICES; LOSS OF USE, DATA OR PROFITS; OR BUSINESS INTERRUPTION)

HOWSOEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT

LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF

THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE .

Uso indicado

El sistema NC4 es un medidor de herramientas láser sin contacto que permite realizar mediciones de

gran precisión a alta velocidad de las herramientas de corte en un centro de mecanizado bajo unas

condiciones de funcionamiento normal .

1-2

Sistema de reglaje de herramientas sin contacto NC4: Consideraciones preliminares

JP 4520240

US 7312433