Adler europe AD 7050 Manual De Uso página 5

MAIN SET INCLUDES (see Picture A)
1. Main unit 2. Garment brush
4. Fuzzy cloth
7. Rectangular brush
10. Cup
PARTS LIST (see: Picture B）
1. Power switch 2. Handle
4. Bottom 5. steam nozzle
6. Indicated light (red/green)
- Red light: heating
- Green light: working.
7. Steam switch
Before first use:
Take out the product and the components, remove all packaging materials, and check for possible damage on any of them.
Assembling accessories:
NOTE: Before any disassembly or maintenance make sure, that the device is turned off and cooled down.
Step 1: Push the rear end of any chosen accessory onto the steam nozzle and lock it by turning it counterclockwise. (see Picture C）.
Step 2: The all brush and nozzle can be slid onto the nozzle adaptor (see Picture D).
Using the device:
Step 1: Place the device on a firm surface.
Step 2: Take out the water container (B3) by sliding it backward and opening the small angular, silicon flap located on it.
Step 3: Use the cup to fill water into the device.
NOTE: When filling the water, pay attention to the marking (MAX). Fill a maximum of 120 ml of distilled water or tap water into the water
container.
Step 4: Close the water silicon flap. And install it into the main device by sliding it into place.
Step 5: Plug the device into the power supply. Slide the power switch and the device will turn on. A red light will appear. Please wait until
the light turns Green before proceeding further.
Step 6: Exchange or insert any wanted accessory.
Step 7: Once the light turns green you can start using the device. The device has 2 working modes:
1. Press and hold the Steam switch (B7). This will generate steam until you release the steam switch.
2. Single press the Steam switch (B7). This will generate steam until you press the Steam switch again or the water tank is empty.
Step 8: Once you are finished using the device, release or unlock the steam switch. Press the power switch to turn the device off.
NOTES:
If the steam volume is reduced or stopped during use, water will probably have to be refilled. To do so please repeat points 2-4 from the
Using the device part of the manual.
Do not use the device with the water container is empty.
It is suggested not to leave any unused water in the tank to avoid mold or lime scale build-up.
It is highly recommended to use only distilled water to avoid lime scale clogging of the device and/or accessories.
Do not add any additives like perfume, vinegar, starch, dirt-cleaning gel, cleaning gel, or other chemical materials to water in the
container.
Store the appliance in a dry location that is protected from frost and direct sunlight.
Allow the device to cool down and accessories to completely dry before storing them.
USAGE – ACCESSORIES
NOTES:
Prior to using the appliance on any surface or textile, always make sure that material is not sensitive to steam by doing a test on a
concealed area first before using it on a whole product/area.
Do not direct the steam at glued laminated edges as the edge may loosen.
Do not use the appliance for cleaning unsealed wood or parquet floors.
Do not use the appliance for cleaning painted or plastic-coated surfaces such as the kitchen or living room furniture, doors, or parquet.
To clean these surfaces, steam a cloth briefly and use it to wipe over the surfaces.
Steam can damage sealed points of the window frame and, at low outside temperatures, lead to tension on the surface of window
panes and hence to glass breakages. Do not direct the steam at sealed points on the window frame. At low outside temperatures, heat up
the window panes by gently steaming the full surface of the glass. Clean the window area with a manual nozzle and cover. To remove the
water, use a squeegee or wipe the surfaces dry.
Plastic/metal brushes can scratch sensitive surfaces. They are not suitable for cleaning sensitive surfaces.
Steam nozzle: The steam nozzle can be used for the following application areas without accessories:
1. For removing slight creases from the hanging clothing items: Steam the clothing item from a distance of 10-20 cm.
2. For wiping damp dust: Steam a cloth briefly and use it to wipe over furniture.
Small plastic/metal round brushes: The round brushes are used for cleaning stubborn dirt that can be removed more easily that way.
Attachment for textile and disinfection: It can be used for cleaning small areas that can be washed down, shower cubicles, and mirrors.
Usually, the microfiber cloth/cleaning disc should be used with this accessory.
A2 - Garment brush – Used on clothes, for removing hair and straightening fabrics.
A3 - Cleaning disc – Can be used alone for ironing clothes.
A4 - Fuzzy cloth – Used with the Cleaning disk. Can be used to clean flat, hard surfaces.
A5 - Stand - Used for storing the device.
A6 - Nozzle adapter – Needed to use with other attachments.
3. Cleaning disc
5. Stander
8. Round brush
3. Water tank
6. Nozzle adapter
9. Pointy nozzle
5