Gewiss CHORUSMART GW 10 581 Instrucciones De Empleo página 24

The SET/PROG key is pressed twice to personalise the preset daily/weekly program or to
make a modification to a previously set cycle.
USER INSTRUCTIONS
Programming
a) The message PROG is displayed on the VDU while the
bar for the first day of the week starts to blink.
The required day is selected with the
The selection is confirmed by pressing the MODE key
within 30 seconds.
b) The profile of the day selected is displayed on the VDU.
c) The time starts to blink.
The keys are used to select the start hour from
which it is required to modify the proposed profile; while
the time profile is being incremented, the column relative
to the selected time will blink. The selection is confirmed
by pressing the MODE key within 30 seconds.
The message ON (or OFF) blinks on the VDU.
The keys can be used to modify the output status,
The modification takes effect starting from the time se-
lected and extends until the next transition or until the
end of the day that is being programmed if there are no
subsequent transitions.
The choice is confirmed by pressing the MODE key with-
in 30 seconds.
24
keys.