Descargar Imprimir esta página

Climadiff CLS35B1 Manual De Instrucciones página 40

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3. TECHNICAL DATA
The nameplate attached to the inside or rear of the appliance (depending on the model) includes the
entire information specific to your appliance.
We recommend that you make a note of its serial number in this booklet prior to installation, so that you
can refer to it later (technical work, request for assistance, etc.).
Once the appliance is installed and loaded, access to it is not so easy.
CAUTION: no assistance can be provided without this information.
4. INSTALLATION INSTRUCTIONS
Before using this appliance
• Remove the exterior and interior packing.
• Before connecting the appliance to the power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• When disposing your appliance, please choose an authorized disposal site.
• Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To level
your Wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
• Adequate ventilation is required, do not block the front air outlet.
• This unit is intended for free-standing installation only. It must never be built-under or built-in. For
proper operation of the appliance, it is imperative to allow good air circulation around the unit. We do
not accept any liability instance of non-compliance with the installation instructions.
• Not designed for placement in adage or basement.
• The appliance is for indoor use only.
• This appliance is intended to be used exclusively for the storage of wine.
• This appliance is using flammability refrigerant. So never damage the cooling pipe work during the
transportation.
• Connect the appliance to a single socket, leaving a 10 cm gap between the back of the cellar and
the wall. Be careful to support it, so that your wine cooler is perfectly level. (The use of a spirit level
is recommended). This will prevent any movement due to instability, generating noise and vibration,
and will ensure that the door seals perfectly.
Attention
• Store wine in sealed bottles.
• Do not overload the cabinet.
• Do not open the door unless necessary.
40

Publicidad

loading

Este manual también es adecuado para:

Cls45b1Cls65b1Cld40b1Cld55b1Cld115b1