Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
WARNING
allow a fluid to flow inside them.
industrial chemicals, and bleach or bleach-containing products, etc, can cause a short circuit.
How to Charge the Battery Pack
NOTICE: The battery pack is shipped partially charged.
Before using it the first time, fully charge the battery pack.
The PWRJUMP function charges a fully-depleted 2.0Ah battery pack to approximately 25%
capacity in 5 minutes.
NOTICE: The remaining 75% charge will be
achieved under the normal charging mode.
a) Charge the battery pack with the correct
charger.
b) Connect the charger to a power supply. The
red Defect Indicator, green Normal Charging
Indicator, and yellow PWRJUMP Indicator
will shine for one second and then go out,
indicating that the charger self-inspection is
completed.
c) Align the raised ribs of the battery pack with
the slot in the charger.
d) Insert the battery pack into the charger
(Fig. 2).
e) The charger will communicate with the battery pack to evaluate the condition of the battery
pack.
f) If the battery pack temperature is within the PWRJUMP charging temperature range and the
battery is significantly depleted, the PWRJUMP indicator will shine yellow.
g) Depress the button to activate PWRJUMP charging. The PWRJUMP light will flash green to
indicate PWRJUMP charging.
h) When the battery has charged to approximately 25% capacity in 5 minutes, the green
Normal Charging Indicator will begin flashing to indicate that normal charging is occurring;
the PWRJUMP indicator will remain green.
i) The green normal charging indicator will keep flashing when charging the battery pack
in the normal charging mode. After the charging is complete, the green normal charging
indicator will stay green.
j) A flickering red defect indicator indicates a defective battery or a bad connection between
the battery and the charger.
k) A solid red defect indicator indicates that the battery is over-temperature. Remove the
battery pack from the charger. If the battery is too hot, cool the battery under air flow. If the
battery is too cold, place it indoors until it reaches room temperature.
l) It is not recommended that the battery pack remain on the charger for more than 24 hours.
NOTICE: If the battery pack cannot accept a charge, the contacts of the charger or battery
pack may be contaminated. Clean the contacts of the charger or battery pack (e. g. by
inserting and removing the battery several times or scrubbing with a cotton swab and alcohol)
or replace the battery pack, as required.
12
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your charger or battery pack in fluid or
Corrosive or conductive fluids, such as seawater, certain
Fig. 2
Attach
Detach
Publicidad
