Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE CERAMIC HOB
BEFORE FIRST USE
IMPORTANT: You should clean the ceramic hob surface (see "Maintenance and cleaning"
section).
✓ You should switch on one cooking zone at a time, for 5 minutes at the maximum setting. This
will help to eliminate any new smell that exists and evaporate any humidity that has formed on
the heating elements duzona transit.
✓ Do not burn off more than one zone at once.
✓ You must place a saucepan filled half full with cold water on each zone as you burn it off.
OPERATION INSTRUCTION
1. POWER ON
✓ After switch on the appliance, the hob will beep for once to
remind power on, all of the indicator digital tubes on the display
screen will lit on for 2s, then the appliance goes into shutdown
mode. Note: If your hob with multi-zona, the corresponding
indicator digital tube decimal point " " will lit on. If your hob with
single zona only, the digital tube decimal point " " will not lit on.
✓ Shutdown status: All the display will close except the high
temperature warning symbol " "; At this time, only the power key
"
" can operated by pressing and holding, and other key
operations are invalid.
2. STANDBY MODE
✓ Under shutdown status, press and hold " " key for 3s, the hob will beep for once and then enter
standby mode.
✓ All the indicator digital tubes of the cooking zone will display " "(The symbol " " will show in
the cooking zone indicator if there is residual heat), timer place will show "
not heat at this time.
✓ Under standby mode, if no any cooking zone heating operation, the appliance will go into
shutdown status automatically after 10s and beep once.
3. HEATING CONTROL
✓ Under standby mode, you can choose the cooking zone by pressing the cooking zone select
key, then press plus or minus key or to adjust the power level of the corresponding cooking zone.
Press and hold plus "
level.
✓ When the hob top is in heating status, press and hold " " power key for 3s to switch off, and
stop all the cooking zones to heat. The corresponding cooking zone indicator of the hob top
which has heated before will display high temperature warning symbol " ".
✓ Under standby mode, if some hob tops still exist residual heat, display will show " ".
✓ If needing to switch off one of the cooking zones, you can select that zone first, then press the
minus key "
" until "0" power level to switch off that zone, and will not affect the heating of the
other cooking zones. When power level reaches "0", the corresponding cooking zone indicator
of the hob top which has heated before will display high temperature warning symbol " ".
" or minus "
" keys can continuously to increase or decrease the power
55
" as well, it will
Publicidad
