Corsair AR RGB Manual De Instrucciones página 5

FAN INSTALLATION FOR iCUE CONTROL
A CORSAIR iCUE lighting controller is required to proceed with this optional setup.
Upgrade to even more robust lighting effects with CORSAIR iCUE software when you add an iCUE lighting
controller (sold separately).
1 TURN OFF COMPUTER
Turn your system off prior to installing your AR RGB fan.
2 MOUNT iCUE LIGHTING CONTROLLER
Find a location for the iCUE lighting controller
that allows the fan RGB LED cable to reach the
controller, then mount it with mounting strips
included with the controller.
*The Lighting Node CORE is used as an
example in this installation; it is recommended
to follow the instructions included with your
chosen iCUE lighting controller.
4 CONNECT FAN TO RGB CONTROLLER
Connect the 4-pin RGB connector from your
AR RGB fan into the iCUE lighting controller in
sequential order from port #1 to #6.
ENGLISH
3 MOUNT AR RGB FAN
Mount the fan inside your case with the
provided mounting screws. Fan mount locations
will vary depending on the case manufacturer.
5 CONNECT iCUE CONTROLLER TO PC
Plug the 9-pin USB cable from the iCUE lighting
controller into an available internal USB 2.0
header on your motherboard or USB hub.
Connect the SATA power connector to an
available SATA connector from your power
supply.
3
OPTIONAL
TOP
SIDE