Publicidad
Idiomas disponibles
Idiomas disponibles
c. Using an external power supply
To ensure long working hours, the camera can use an external
power supply. The DC-IN interface are as shown in the figure:
DC-IN interface
Notice:
Please use a standard external power supply ： DC 6V/2.0A,
3.5mm interface. The wrong external power supply can damage
the camera. Do not remove the internal battery when using an
external power source. When the external power supply is not
used, the waterproof plug must be covered.
4. Detecting the PIR Sensors
Insert 8x 1.5V AA batteries and a formatted memory card, switch
to 'TEST'mode, waving your hand in front of the camera lens, If the
red light is flashing, it indicates the side PIR sensors are working
properly and the if green light is flashing, it indicates the main PIR
sensor is also working properly.
Press OK button to take a photo manually. Then press MODE button
to check the photo you have taken. If it successes, it indicates the
camera works well.
+
11
-
+
-
EN
Publicidad
