Assembly; Operation - Ryobi P135 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the following purpose:
 Charging RYOBI 18V Li-Ion batteries
CAUTION:
If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery. Take the charger and battery to your nearest
service center for service or replacement.
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

KEY HOLE HANGER
See Figure 1, page 8.
To mount the charger, only use the key hole hanging feature.
Screws should be installed so that the center distance is 9 in.
USING THE USB CHARGING PORT
See Figure 2, page 8.
The USB charging port provides charging power of 5 Volts
DC at up to 2 amps for your cell phone, MP3 player, tablet,
or other USB devices. Consult the owner's manual for your
device for specific charging requirements.
Connect one end of a USB cable (not provided) to your device
and the other end to a USB charging port on the charger to
begin charging your device.
NOTICE:
Attempting to charge devices rated more than 2 amps
could damage the USB charging ports and/or the charger.
CHARGING
See Figure 3, page 8.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time is approximately 30 minutes and is dependent
upon the type of battery pack.
NOTE: Charger charges batteries one at a time; charger does
NOT charge multiple batteries simultaneously.
4 — English