Bosch Professional GIC 12V-5-27 C Manual Original página 29

Digital inspection camera
Recommended chargers
A) Measured across the diagonal of the image
B) at 50 mm distance in a dark environment
C) with camera display, with AutoUp function, average display brightness, illumination light with
50 % brightness
D) with GBA 12V 2.0Ah
E) Depends on battery in use
Assembly
Power supply
The inspection camera can be operated either with a Bosch lithium-ion rechargeable bat-
tery, with commercially available non-rechargeable batteries or with commercially avail-
able NiMH rechargeable batteries.
The battery charge indicator (d) will indicate the state of charge of the Li-ion battery,
non-rechargeable batteries or NiMH batteries on the display.
Operation with Battery Adapter (see figure A)
The non-rechargeable or NiMH rechargeable batteries are inserted into the battery ad-
apter.
The battery adapter is intended only for use in designated Bosch inspection cam-
u
eras and must not be used with power tools.
To insert the non-rechargeable/rechargeable batteries, slide the receptacle (22) of the
battery adapter into the bay (21). Place the non-rechargeable/rechargeable batteries in
the receptacle as shown in the picture on the cap (24). Slide the cap over the cover until
you feel it click into place and it is flush with the handle of the inspection camera.
To remove the non-rechargeable/rechargeable batteries , press the release
buttons (23) of the cap (24) and pull off the cap. Pull out the cover (22) from inside the
port (21).
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
Remove the non-rechargeable/rechargeable batteries from the inspection cam-
u
era when not using it for longer periods. The batteries and rechargeable batteries
can corrode and self-discharge if stored for prolonged periods in the inspection cam-
era.
Bosch Power Tools
English | 29
GIC 12V-5-27 C
GAL 12...
GAX18 ...
1 609 92A 89L | (17.03.2023)