Publicidad
Idiomas disponibles
Idiomas disponibles
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
M5
Top Panel
Bottom Panel
Side Panels (2)
Back Panels (2)
Doors (2)
Interior Shelf
Shelf Clips (4)
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
M5
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
ASSEMBLING THE CABINET
See Figures 2 - 9.
Align holes in top panel and upper back panel as shown
in Figure 2.
NOTE: Octagonal bends should face inward toward the
interior of the cabinet.
M5
Bumpers (2)
M5 Bolts (22, 2 additional)
M5 Nuts (22, 2 additional)
M4 Bolts (4, 2 additional)
M4 Nuts (4, 2 additional)
Mounting Screws (4)
Operator's Manual
M5
M5
M5
ASSEMBLY
Insert M5 bolts (2) through the two centered back holes
of the panels as shown in Figure 2. Secure with M5 nuts
(2).
NOTE: M5 bolts and nuts should only be used to secure
the side and back facing panels of the cabinet. M4 bolts
and nuts should only be used to secure the front facing
corners of the cabinet.
Align holes in top panel and right side panel as shown in
Figure 3.
NOTE: Side panel tabs fit around outside of top panel.
The upper back panel edges will fit inside the side panel.
Insert M5 bolts (4) through the side hole and back holes
of the panels as shown in Figure 3. Secure with M5 nuts
(4).
Repeat steps above to attach the left side panel.
TOP PANEL
M5 NUT
M5 BOLT
M5
M5
M5
SIDE
PANEL
4 — English
M5
M5
OCTAGONAL BENDS
TAB
M5
M5
M5
M5
M5
M5
M5
M5 BOLT
UPPER BACK
PANEL
Fig. 2
M5 NUT
M5
M5
M5
M5
Fig. 3
M5
Publicidad
